What is Firewall
A firewall is a device or set of devices designed to permit or deny network transmissions based upon a set of rules and is frequently used to protect networks from unauthorized access while permitting legitimate communications to pass.
Many personal computer
operating systems include software-based firewalls to protect against threats from the public Internet. Many
routers that pass data between networks contain firewall components and, conversely, many firewalls can perform basic routing functions.
History of firewall
The term
firewall originally referred to a wall intended to confine a fire or potential fire within a building; cf.
firewall (construction). Later uses refer to similar structures, such as the metal sheet separating the engine compartment of a vehicle or aircraft from the passenger compartment.
· The
Morris Worm spread itself through multiple vulnerabilities in the machines of the time. Although it was not malicious in intent, the Morris Worm was the first large scale attack on Internet security; the online community was neither expecting an attack nor prepared to deal with one.
First generation: packet filters
The first paper published on firewall technology was in 1988, when engineers from
Digital Equipment Corporation (
DEC) developed filter systems known as
packet filter firewalls. This fairly basic system was the first generation of what became a highly evolved and technical internet security feature. At
AT&T Bell Labs, Bill Cheswick and
Steve Bellovin were continuing their research in packet filtering and developed a working model for their own company based on their original first generation architecture.
This type of packet filtering pays no attention to whether a packet is part of an existing stream of traffic (i.e. it stores no information on connection "state"). Instead, it filters each packet based only on information contained
in the packet itself (most commonly using a combination of the packet's source and destination address, its protocol, and, for
TCP and
UDP traffic, the
port number).
TCP and UDP protocols constitute most communication over the Internet, and because TCP and UDP traffic by convention uses
well known ports for particular types of traffic, a "stateless" packet filter can distinguish between, and thus control, those types of traffic (such as web browsing, remote printing, email transmission, file transfer), unless the machines on each side of the packet filter are both using the same non-standard ports.
Packet filtering firewalls work mainly on the first three layers of the OSI reference model, which means most of the work is done between the network and physical layers, with a little bit of peeking into the transport layer to figure out source and destination port numbers.
[2] When a packet originates from the sender and filters through a firewall, the device checks for matches to any of the packet filtering rules that are configured in the firewall and drops or rejects the packet accordingly. When the packet passes through the firewall, it filters the packet on a protocol/port number basis (GSS). For example, if a rule in the firewall exists to block telnet access, then the firewall will block the IP protocol for port number 23.
source from : http://en.wikipedia.org/wiki/Firewall_%28networking%29
